easYgen-2000 Series Option Manual
Brief Overview
NOTICE!
This option manual must be used together with the
device standard manual. A option manual only
describes the additional functionality of the device.
Please refer to Ä ‘Additional functionality’ on page 5
for details.
The following standard manual is required to install,
commission and operate the device:– easYgen-2200/2500 manual (37535)
easYgen-2500 (housing)
1 Analog output and generator CT terminal
2 Mains/generator/busbar PT terminal
3 Service port connector (USB/RS-232)1
4 Relay outputs terminal
5 Discrete inputs terminal
6 CAN bus interface terminal #1
7 Analog input/outputs terminal and discrete inputs terminal
8 Relay outputs terminal
9 CAN bus interface terminal #2
10 RS-485 interface terminal
Optional configuration cable for ToolKit configuration
software and external extensions/applications
required:
– USB connector: DPC-USB direct configuration
cable
– P/N 5417-1251– RS-232 connector: DPC-RS-232 direct configura
tion cable – P/N 5417-557
The easYgen-2000 Series are control units for engine-generator
system management applications.
The control units can be used in applications such as: rental gener
ators, stand-by, AMF and peak shaving.
Sample application setup
A typical application mode for the control unit is the use for opera
tion of the GCB.
n In this case, the easYgen will function as an engine control with
generator, mains and engine protection.
n The control unit can open and close the generator circuit
breaker (GCB).
For a listing of additional application modes and setups
please refer to 'Chapter: Application' in
easYgen-2200/2500 manual (37535).
Additional functionality
The easYgen-2500 Rental controllers have some addi
tional features compared to the standard
easYgen-2500 controllers. The differences are listed
below.– Switchable parameter sets. Refer to Ä Chapter
2.1.1 ‘Switchable Parameter Sets’ on page 15 for
details.
– Period of use counter. Refer to Ä Chapter 2.1.2
‘Configure Counters’ on page 21 for details.
– Specialised menu screens. Refer to Ä Chapter
2.2.1 ‘Front Panel Access’ on page 21 for details.
– Open delta connected system. Refer to
easYgen-2200/2500 manual (37535) for details.
The setting range of "Generator voltage meas
uring" (parameter 1851) was extended to the entry
"3Ph 4W OD"
General Information
About This Manual
Revision History
Depiction Of Notes And Instructions
Safety instructions are marked with symbols in these instructions.
The safety instructions are always introduced by signal words that
express the extent of the danger.
DANGER!
This combination of symbol and signal word indicates
an immediately-dangerous situation that could cause
death or severe injuries if not avoided.
WARNING!
This combination of symbol and signal word indicates
a possibly-dangerous situation that could cause death
or severe injuries if it is not avoided.
CAUTION!
This combination of symbol and signal word indicates
a possibly-dangerous situation that could cause slight
injuries if it is not avoided.
