S600+ HardwareMechanics
Processor Board
I/O Board
Prover Board
HART Board
Board Addressing
Overview
.jpg)
Mechanical:
Modular design
Standard case accom CPU + 3 x I/O boards
Panel mounting modules
Extendable to 10 streams
Main Processor Board - P152
Heart of the FloBoss S600+
ColdFire MPC8313C • 333MHz / 300 MIPS
256 Mb FLASH
4 Mb SRAM (non-volatile)
10 Available Serial Ports • 3 RS232 (1 dedicated download port on front panel) • 3 RS422 / 485 • 4 RS485
.jpg)
2 Ethernet Ports
USB Port
P152 – Power Requirements
24 Volts DC supply (2 Amps)
Will operate between 20 & 32 Volts DC
Protected by a 2.5 Amp anti-surge fuse
Start-up inrush current may draw 6Amps (Approx 100ms)
Significant when multiple machines are powered from a single supply
.jpg)
P152 – Power Source
On-board regulated 15V & 24V Supplies
Powering Loops
Powering Pre-amplifiers
Protected by Thermal fuses
P152 – Battery Backup
Field-replaceable Lithium Cell
Backup contents of SRAM (Configuration)
Backup BIOS
On-board Calendar Clock
Lithium Rechargeable 3 Volt, 1500 mAh
P152 – Power Source
• Normally Open or Normally Closed terminals provide the watchdog status
A CPU failure causes the relay to de-energize
.jpg)
P144 - I/O Board
• For field wiring, the backplate provides three low-density D-type connectors labeled SKT-A, SKT-B, and SKT-C
P144 - I/O Board
Used to measure field Process Signals
12 x Analogue Inputs
4 x Analogue Outputs
16 x Digital Inputs
12 x Digital Outputs
4 x Pulse Inputs
5 x Pulse Outputs
3 x Frequency (Density) Inputs
3 x PRT/RTD Inputs
P154 – Prover Board
Dedicated Prover Interface Card
Compact or Microprover
Unidirectional & Bidirectional
1, 2, or 4 Detector Switches
Master Meter
P188 – HART Board
12 Channel HART Board
Up to 8 devices per channel
Maximum of 50 devices
FloBoss S600
Board Types:
• P152 – Processor Board • P144 – Standard I/O Board • Analogue / Digital / Pulses • P154 – Prover I/O Board • Additional Digital / Pulses / NO Analogue • P148 – Turbine Mezzanine • P188 – HART I/O Board • 12 Channels
