DYNA Programmable Governor for Isochronous GeneratorsCalibration and Troubleshooting for DPG-2101, DPG-2102, DPG-2103, DPG-2104

The DPG-2100 governors are state of the art digital controllers. The controller

can be used on both diesel and gas engines. The DPG-2100 series eliminates the need to have multiple controllerson the shelf. The governor can operateover a frequency range of 1000to11,000Hz, and over a nominal voltagerange of 9 to 30VDC

DEFINITIONS

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. 

 • th  DANGER—Indicates a hazardous situation which, if not avoided, will result in dea or serious injury. 

 • WARNING—Indicates a hazardous situation which, if not avoided, could result in death or serious injury. 

 • CAUTION—Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. 

 • NOTICE—Indicates a hazard that could result in property damage only (including damage to the control). 

 • IMPORTANT—Designates an operating tip or maintenance suggestion.

The engine, turbine, or other type of prime mover should be equipped with an overspeed shutdown device to protect against runaway or damage to the prime mover with possible personal injury, loss of life, or property damage. The overspeed shutdown device must be totally independent of the prime mover control system. An overtemperature or overpressure shutdown device may also be needed for safety, as appropriate.

Read this entire manual and all other publications pertaining to the work to be performed before installing, operating, or servicing this equipment. Practice all plant and safety instructions and precautions. Failure to follow instructions can cause personal injury and/or property damage.

Any unauthorized modifications to or use of this equipment outside its specified mechanical, electrical, or other operating limits may cause personal injury and/or property damage, including damage to the equipment. Any such unauthorized modifications: (i) constitute "misuse" and/or "negligence" within the meaning of the product warranty thereby excluding warranty coverage for any resulting damage, and (ii) invalidate product certifications or listings.

To prevent damage to a control system that uses an alternator or battery-charging device, make sure the charging device is turned off before disconnecting the battery from the system.

To prevent damage to electronic components caused by improper handling, read and observe the precautions in Woodward manual 82715, Guide for Handling and Protection of Electronic Controls, Printed Circuit Boards, and Modules.

WOODWARD DPG-2302-001S

Woodward DPG-2223-002

WOODWARD DPG-2201-002

Woodward DPG-2133-002